User’s Manual

PE100A

4.1 Requirements

Before you start setting up your Edge Computer, please make sure you have

the following available:

• 1 x USB Type-C® cable with data transfer function

(to connect your PC to the PE100A’s data port)

• 1 x Power supply

• 1 x Monitor with HDMI cable

• 1 x Keyboard and Mouse set

NOTE: Ensure to use the bundled power supply, or, if you are using

another power supply, ensure to use a 12~24V power supply.

Before you begin the flashing procedure, please ensure of the following:

• The PE100A is completely powered off, and the power cord and cables

connecting your PE100A to your computer are all disconnected.

• The Boot Mode switch are set to eMMC mode, please refer to Boot

Mode switch under the 1.2.2 Onboard switch section for more

information on setting the Boot Mode switch

4.2 Flashing the PE100A