User Manual
Table Of Contents
- Contents
- Notices
- Safety information
- Care & Cleaning
- Takeback Services
- Chapter 1: Product introduction
- 1.1 Welcome!
- 1.2 Package contents
- 1.3 Monitor introduction
- Chapter 2: Setup
- 2.1 Attaching the arm/base
- 2.2 Detaching the arm/base (for VESA wall mount)
- 2.3 Adjusting the monitor
- 2.4 Connecting the cables
- 2.5 Turning on the monitor
- Chapter 3: General instructions
- 3.1 OSD (On-Screen Display) menu
- 3.2 Specifications summary
- 3.3 Outline Dimensions
- 3.4 Troubleshooting (FAQ)
- 3.5 Supported operating modes
2-4 Chapter 2: Setup
2.4 Connecting the cables
1. Connect the cables as the following instructions:
For service only
: Connect one end of the power cord securely to
the monitor’s AC input port, the other end to a power outlet.
:
a. Plug one end of the HDMI/DisplayPort cable to the monitor’s HDMI/
DisplayPort jack.
b. Connect the other end of the HDMI/DisplayPort cable to your device's
HDMI/DisplayPort jack.
connect the end with plug type to the monitor’s
earphone jack when an HDMI/DisplayPort/USB Type-C (DisplayPort Alternate
Mode) signal is fed.
:
»
Upstream: Use the supplied USB Type-C to Type-C or USB Type-C
to Type-A cable. Make sure your computer is installed with the latest
Windows 7/Windows 8.1/Windows 10 operating system. That will enable
the USB ports on the monitor to work.
»
Downstream: Plug the USB Type-A cable of your device to the monitor's
USB Type-A jack.
»
USB Type-A jack can be used for Color Calibrator.
When these cables are connected, you can choose the desired signal
from the Input Select item in the OSD menu.