User Guide

3-3ASUS PA248QV Series LCD Monitor
Below table shows the default congurations for each ProArt Preset mode:
Function
Standard
Mode
sRGB
Mode
Rec. 709
Mode
Scenery
Mode
Reading
Mode
Darkroom
Mode
Rapid
Rendering
Mode
User Mode
1/User
Mode 2
Color Engine Off Off Off Off Off Off Off Off
Color Temp. 6500K
Fixed
6500K
6500K 6500K Disable 6500K 6500K 6500K
Brightness 50 100 nits 100 nits 100 Enable (9) Enable (2) 50 50
Contrast 80
Fixed
80
80 80
Disable
(80)
80 80 80
ASCR Disable Disable Disable Off Disable Off Disable Disable
Sharpness Enable (0) Enable (0) Enable (0) Enable (0) Enable (0) Enable (0) Enable (0) Enable (0)
Saturation
Middle
(50)
Disable
Middle
(50)
Middle
(50)
Disable
Middle
(50)
Middle
(50)
Middle
(50)
Hue
Middle
(50)
Disable
Middle
(50)
Middle
(50)
Disable
Middle
(50)
Middle
(50)
Middle
(50)
Advanced
Setting
Enable
(Default)
Disable
Enable
(Default)
Enable
(Default)
Enable
(Default)
Enable
(Default)
Enable
(Default)
Enable
(Default)
Gamma
Enable
(2.2)
Fixed
2.2
Enable
(2.4)
Disable
Enable
(2.2)
Enable
(2.2)
Enable
(2.2)
Enable
(2.2)
VividPixel 0 0 0 0 0 0 0 0
 
In this function, you can adjust the blue light filter level.
ASUS P A 2 4 8 Q V
Standa r d M o d e D is p l ay P o rt 19 2 0 x 1 20 0 @ 6 0 Hz
Le v el 0
Le v el 1
Le v el 2
Le v el 3
Le v el 4
Blue Light Filter
 No change.
  The higher the level, the less blue light is scattered.
When Blue Light Filter is activated,the default settings of Standard Mode
will be automatically imported. Between Level 1 to Level 3, the Brightness
function is user-configurable. Level 4 is optimized setting. It is compliance
with TUV Low Blue Light Certification. The Brightness function is not user-
configurable. Enabling this function automatically turns off ECO Mode.
Please refer to the following to alleviate eye strains: