Computer Hardware User Manual
Table Of Contents
- Contents
- Chapter 1: Product introduction
- Chapter 2: Hardware information
- 2.1 Before you proceed
- 2.2 Motherboard overview
- 2.3 Building your computer system
- 2.3.1 Additional tools and components to build a PC system
- 2.3.2 CPU installation
- 2.3.3 CPU heatsink and fan assembly installation
- 2.3.4 DIMM installation
- 2.3.5 Motherboard installation
- 2.3.6 ATX Power connection
- 2.3.7 SATA device connection
- 2.3.8 Front I/O Connector
- 2.3.9 Rear panel connection
- 2.3.10 Audio I/O connections
- 2.3.11 USB BIOS Flashback
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- Chapter 3: BIOS setup
- Chapter 4: Software support
- Chapter 5: Multiple GPU technology support
5-8 Chapter 5: Multiple GPU technology support
5.2.4 Installing four SLI-ready graphics cards
1. Prepare four SLI-ready graphics cards.
2. Insert the four graphics card into the PCIEX16 slots. If your motherboard
has more than two PCIEX16 slots, refer to Chapter 2 in this user manual
for the locations of the PCIEX16 slots recommended for multi-graphics card
installation.
3. Ensure that the cards are properly seated on the slots.
4. Align and rmly insert the 4-Way SLI bridge connector to the goldngers on
each graphics card. Ensure that the connector is rmly in place.
5. Connect four independent auxiliary power sources from the power supply to
the four graphics cards separately.
6. Connect a VGA or a DVI cable to the graphics card.
4-Way SLI bridge