Instruction Manual
Table Of Contents
- Notices
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 Ai Overclock Tuner [Auto]
- 2.4.2 Memory Frequency [Auto]
- 2.4.3 iGPU Max. Frequency [Auto]
- 2.4.4 GPU Boost
- 2.4.5 DRAM Timing Control
- 2.4.6 CPU Power Management
- 2.4.7 CPU Offset Mode Sign [+]
- 2.4.8 iGPU Offset Mode Sign [+]
- 2.4.9 VCCIO Voltage [Auto]
- 2.4.10 VCCSA Voltage [Auto]
- 2.4.11 PCH Voltage [Auto]
- 2.4.12 CPU Spread Spectrum [Auto]
- 2.5 Advanced menu
- 2.6 Monitor menu
- 2.7 Boot menu
- 2.8 Tools menu
- 2.9 Exit menu
1-13 Chapter 1: Product introduction
3. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The S/PDIF module is purchased separately.
Do not forget to connect the fan cables to the fan connectors. Insufcient air ow inside the
system may damage the motherboard components. These are not jumpers! Do not place
jumper caps on the fan connectors!
2. CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Only the 4-pin CPU fan supports the ASUS FanXpert feature.
P8H67-I
P8H67-I fan connectors
CPU_FAN
CPU FAN PWM
CPU FAN IN
CPU FAN PWR
GND
CHA_FAN
CPU FAN PWM
CPU FAN IN
CPU FAN PWR
GND
SPDIF_OUT
+5V
SPDIFOUT
GND
P8H67-I
P8H67-I Digital audio connector