Manual
Table Of Contents
- P7P55D-E Premium specifications summary
- About this guide
- Safety information
- Notices
- Chapter 1: Product introduction
- Chapter 2: Hardware information
- Chapter 3: BIOS setup
- 3.1 Knowing BIOS
- 3.2 Updating BIOS
- 3.3 BIOS setup program
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.5.1 Ai Overclock Tuner [Auto]
- 3.5.2 CPU Ratio Setting [Auto]
- 3.5.3 Intel(R) SpeedStep(TM) Tech [Enabled]
- 3.5.4 Intel(R) TurboMode Tech [Enabled]
- 3.5.5 Xtreme Phase Full Power Mode [Auto]
- 3.5.6 DRAM Frequency [Auto]
- 3.5.7 QPI Frequency [Auto]
- 3.5.8. DRAM Timing Control [Auto]
- 3.5.9 CPU Differential Amplitude [Auto]
- 3.5.10 CPU Clock Skew [Auto]
- 3.5.11 CPU Voltage Mode [Offset]
- 3.5.12 IMC Voltage [Auto]
- 3.5.13 DRAM Voltage [Auto]
- 3.5.14 CPU PLL Voltage [Auto]
- 3.5.15 PCH Voltage [Auto]
- 3.5.16 DRAM DATA REF Voltage on CHA/B [Auto]
- 3.5.17 DRAM CTRL REF Voltage on CHA/B [Auto]
- 3.5.18 Load-Line Calibration [Auto]
- 3.5.19 CPU Spread Spectrum [Auto]
- 3.5.20 PCIE Spread Spectrum [Auto]
- 3.6 Advanced menu
- 3.7 Power menu
- 3.8 Boot menu
- 3.9 Tools menu
- 3.10 Exit menu
- Chapter 4: Software support
- Chapter 5: Multiple GPU technology support
3-34 Chapter 3: BIOS setup
Chapter 3
3.8.3 Security
The Security menu items allow you to change the system security settings. Select an item
then press <Enter> to display the conguration options.
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Passward
BIOS SETUP UTILITY
Boot
<Enter> to change
password.
<Enter> again to
disable password.
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor Password item
on top of the screen shows the default Not Installed. After you set a password, this item
shows Installed.
To set a Supervisor Password:
1. Select the Change Supervisor Password item and press <Enter>.
2. From the password box, type a password composed of at least six letters and/or
numbers, then press <Enter>.
3. Conrm the password when prompted.
The message Password Installed appears after you successfully set your password.
To change the supervisor password, follow the same steps as in setting a user password.
To clear the supervisor password, select the Change Supervisor Password then press
<Enter>. The message Password Uninstalled appears.
If you forget your BIOS password, you can clear it by erasing the CMOS Real Time Clock
(RTC) RAM. See section 2.7.1 Rear panel connectors for information on how to erase the
RTC RAM.
After you have set a supervisor password, the other items appear to allow you to change
other security settings.