Manual
Table Of Contents
- P7P55D-E Premium specifications summary
- About this guide
- Safety information
- Notices
- Chapter 1: Product introduction
- Chapter 2: Hardware information
- Chapter 3: BIOS setup
- 3.1 Knowing BIOS
- 3.2 Updating BIOS
- 3.3 BIOS setup program
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.5.1 Ai Overclock Tuner [Auto]
- 3.5.2 CPU Ratio Setting [Auto]
- 3.5.3 Intel(R) SpeedStep(TM) Tech [Enabled]
- 3.5.4 Intel(R) TurboMode Tech [Enabled]
- 3.5.5 Xtreme Phase Full Power Mode [Auto]
- 3.5.6 DRAM Frequency [Auto]
- 3.5.7 QPI Frequency [Auto]
- 3.5.8. DRAM Timing Control [Auto]
- 3.5.9 CPU Differential Amplitude [Auto]
- 3.5.10 CPU Clock Skew [Auto]
- 3.5.11 CPU Voltage Mode [Offset]
- 3.5.12 IMC Voltage [Auto]
- 3.5.13 DRAM Voltage [Auto]
- 3.5.14 CPU PLL Voltage [Auto]
- 3.5.15 PCH Voltage [Auto]
- 3.5.16 DRAM DATA REF Voltage on CHA/B [Auto]
- 3.5.17 DRAM CTRL REF Voltage on CHA/B [Auto]
- 3.5.18 Load-Line Calibration [Auto]
- 3.5.19 CPU Spread Spectrum [Auto]
- 3.5.20 PCIE Spread Spectrum [Auto]
- 3.6 Advanced menu
- 3.7 Power menu
- 3.8 Boot menu
- 3.9 Tools menu
- 3.10 Exit menu
- Chapter 4: Software support
- Chapter 5: Multiple GPU technology support
2-36 Chapter 2: Hardware information
Chapter 2
8. IEEE 1394a port connector (10-1 pin IE1394_2)
This connector is for an IEEE 1394a port. Connect the IEEE 1394a module cable
to this connector, then install the module to a slot opening at the back of the system
chassis.
Never connect a USB cable to the IEEE 1394a connector. Doing so will damage the
motherboard!
9. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
The COM module is purchased separately.
The IEEE 1394a module is purchased separately.