Specifications

2-282-28

2-28

Chapter 2: Hardware informationChapter 2: Hardware information

Chapter 2: Hardware information

The connectors do not support ATAPI devices.

2.2.

Marvell IDE connector (40-1 pin PRI_EIDE [red])Marvell IDE connector (40-1 pin PRI_EIDE [red])

Marvell IDE connector (40-1 pin PRI_EIDE [red])

This connector is for Ultra ATA 133/100/66 signal cables. The

Marvell

IDE connectors support up to two IDE hard disk drives for

easier data storage.

2.7.22.7.2

2.7.2

Internal connectorsInternal connectors

Internal connectors

1.1.

Floppy disk drive connector (34-1 pin FLOPPY)Floppy disk drive connector (34-1 pin FLOPPY)

Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other

end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection

when using a FDD cable with a covered Pin 5.

P5WD2-E PREMIUM Floppy Disk Drive Connector

NOTE: Orient the red markings o

the floppy ribbon cable to PIN 1.

PIN 1

FLOPPY

P5WD2-E

P5WD2-E PREMIUM RAID Connector

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_EIDE

PIN 1

P5WD2-E