Specifications

2-22 Chapter 2: Hardware information
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
These connectors are set IDE mode by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors.
P5GC-MR
R
P5GC-MR SATA Connectors
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA1
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
SATA2
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXN3
RSATA_RXP3
GND
SATA3
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXN4
RSATA_RXP4
GND
SATA4
Serial ATA hard disk drive connection
Con nect or Se tting Use
SATA1/SATA2 Master Boot disk
SATA3/SATA4 Slave Data disk
• When using the connectors in IDE mode, connect the primary (boot) hard
disk drive to the SATA1 or SATA2 connector. Refer to the table below for the
recommended SATA hard disk drive connections.