User's Manual

ASUS P5BV-C Series 4-15
When the USB Function is set to 2 USB Ports or 4 USB Ports, the following
items appear.
USB 2.0 Controller [Enabled]
Allows you to enable or disable the USB 2.0 controller.
Conguration options: [Enabled] [Disabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB. The AUTO option
disables legacy support if there is no USB device connected.
Conguration options: [Disabled] [Enabled] [Auto]
USB2.0 Controller mode [HiSpeed]
Allows you to select the USB2.0 controller mode.
Conguration options: [FullSpeed] [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Allows yout to enable or disable the BIOS EHCI Hand-Off support function.
Conguration options: [Disabled] [Enabled]
USB Mass Storage Device Conguration
USB Mass Storage Reset Delay [20 Sec]
Allows you to set the time that POST waits for the USB mass storage device after
starting unit command. Conguration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to select device emulation type. If set to Auto, the part of less than
530MB of USB devices is emulated as oppy disk, and the rest is emulated
as hard disk. Conguration options: [Auto] [Floppy] [Forced FDD] [Hard Disk]
[CDROM]
Select Screen
Select Item
+- Change Option
F1 General Help
F10SaveandExit
ESCExit
BIOS SETUP UTILITY
Advanced
USBMassStorageDeviceConguration
USBMassStorageResetDelay [20Sec]
Device #1 Netac
 EmulationType   [Auto]
Number of Seconds
POST waits for the
USB mass storage
device after start
unit command.