User's Manual

2-30 Chapter 2: Hardware information

11. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch.

Connect one end of the chassis intrusion sensor or switch cable to this

connector. The chassis intrusion sensor or switch sends a high-level signal to

this connector when a chassis component is removed or replaced. The signal

is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a

jumper cap. Remove the jumper caps only when you intend to use the chassis

intrusion detection feature.

P5BV-C/4L

Chassis Intrusion Connector

CHASSIS

+5VSB_MB

Chassis Signal

GND

(Default)

P5BV-C/4L

TPM Connector

TPM

3.3V

AD0

PWRDW#

AD1

AD2

SERIRQ#

CLKRUN#

GND

PCICLK

FRAME#

PCIRST#

AD3

GND

3.3VSB

GND

12. TPM connector (20- pin TPM)

This connector is used to connect a Trusted Platform Module (TPM) Card.

You need to install ASUS TPM card to use this feature function.

The TPM module is purchased separately.