User's Manual

5-10 Chapter 5: Driver installation
5.3.3 Creating a RAID 10 set (RAID 10)
To create a RAID 10 set:
1. From the utility main menu, select
1. Create RAID Volume, then press
<Enter>. This screen appears.
2. Enter a name for the RAID 10 set, then press <Enter>.
3. When the
RAID Level item is highlighted, press the up/down arrow key to
select RAID 10(RAID0+1), then press <Enter>.
4 When the
Disks item is highlighted, press <Enter> to select the hard disk
drives to congure as RAID. The SELECT DISKS screen appears.
5 Use the up/down arrow key to highlight a drive, then press <Space> to
select. A small triangle marks the selected drive. Press <Enter> after
completing your selection.
6. When the
Stripe Size item is highlighted, press the up/down arrow key to
select the stripe size for the RAID 10 array, then press <Enter>. The available
stripe size values range from 8 KB to 128 KB. The default stripe size is 64
KB.
Intel(R)MatrixStorageManagerOptionROMv5.0.0.1032ICH7RwRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reserved.
[ CREATE ARRAY MENU ]
[ DISK/VOLUME INFORMATION ]
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive and
cannot contain special characters.
Name:
RAID Level:
Disks:
StripSize:
Capacity:
Volume10
RAID10(RAID0+1)
SelectDisks
128KB
XXX.X GB
Create Volume
[↑↓]-Change[TAB]-Next[ESC]-PreviousMenu[Enter]-Select
We recommend a lower stripe size for server systems, and a higher stripe size
for multimedia computer systems used mainly for audio and video editing.
7. Key in the RAID volume capacity that you want then press <Enter> when
the Capacity item is highlighted. The default value indicates the maximum
allowed capacity.