User Guide

20 ASUS AP5000 Installation Guide
III. Integration Procedures
Fig 3-19: Cable Path of Floppy, IDE, CD-ROM, and SCSI
DRIVE SETUP
To install device drives on fix-type drive bay is quite straight forward, sim-
ply by screwing the device, inserting it to housing and down at connecting
necessary cables. But for Hot-Swap drive bay, the cables connecting and
means of indicator light on drive bay are quite complex. This section shows
that the installation of slot card with drive bay, the specification of indica-
tor light, device installation and the recommendation of drive position on
the housing.
CABLING
There are three sets of cables, and their locations are indentified in Fig
3-18 and Fig 3-19.
Fig 3-18: Cable locations
III. Integration
Connections
Cabling path for CD-ROM/IDE
drives
Cabling path for SCSI hard disk
Cabling path for Floppy
Cabling path for Floppy/CD-ROM/IDE drives
Cabling path for SCSI