User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- Chapter 4: Software Support
- Chapter 5: RAID Support
- 5.1 RAID configurations
- 5.1.1 RAID definitions
- 5.1.2 Installing Serial ATA hard disks
- 5.1.3 Setting the RAID item in BIOS
- 5.1.4 Intel® Rapid Storage Technology enterprise SATA Option ROM Utility
- 5.1.5 Creating a RAID set
- 5.1.6 Deleting a RAID set
- 5.1.7 Resetting disks to Non-RAID
- 5.1.8 Exiting the Intel® Rapid Storage Technology enterprise SATA Option ROM utility
- 5.1.9 Rebuilding the RAID
- 5.1.10 Setting the Boot array in the BIOS Setup Utility
- 5.2 Intel® Rapid Storage Technology enterprise (Windows)
- 5.1 RAID configurations
- Chapter 6: Multi GPU Support
- Appendix
ASUS P10S WS
4-13
Chapter 4
4.4.1 Ai Charger+
Ai Charger+ allows you to fast-charge your portable BC 1.1* mobile devices on your
computer’s USB port three times faster than the standard USB devices**.
Launching Ai Charger+
To launch Ai Charger+, click on the left of the AI Suite 3 main menu, then select Ai
Charger+.
Ai Charger+ is available only in selected motherboard models.
Tick to enable or
disable Ai Charger+
Click to apply the
selection
Ai Charger+ screen
• Check the manufacturer if your USB device is a Battery Charging Specication 1.1
(BC 1.1) compliant or compatible device.
• Actual charging speeds may vary depending on the charging rate and specications of
your USB device.
• To ensure normal charging function, disconnect and reconnect your USB device every
time you enable or disable Ai Charger+.
• Ai Charger+ does not support USB hubs, USB extension cables, and generic USB
cables.