User Guide
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- Chapter 4: Software Support
- Chapter 5: RAID Support
- Appendix
ASUS P10S-M WS Series
1-23
Chapter 1
3. Serial ATA 6.0 Gbps connectors (7-pin SATA 6Gbps_1-8 connectors [Gray])
Supported by the Intel
®
C236 chipset, these connectors are for the Serial ATA signal
cables for Serial ATA hard disk drives that allows up to 6Gb/s of data transfer rate.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 10,
or RAID 5 conguration.
• These connectors are set to [AHCI Mode] by default. If you intend to create a Serial
ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID
Mode]. Refer to section 5.1.3 Setting the RAID mode in BIOS for details.
• Before creating a RAID set, refer to the manual bundled in the motherboard support
DVD.
4. VGA connector (16-1 pin VGA_HDR1) (for P10S-M WS/IPMI-O only)
This connector supports the VGA High Dynamic-Range interface.