User Manual

2
1.3 Feature Summary
Table 2 summarizes the major features of the Intel® NUC 11 Extreme Kits.
Table 2. Feature Summary
Form Factor
357mm x 189mm x120mm
Processor
• Soldered-down Intel® processor
o Integrated graphics
o Integrated memory controller
• The following processors are supported as intalled in the corresponding NUC 11 Extreme
Compute Element
o Intel® Core™ i9-11900KB
o Intel® Core™ i7-11700B
PCH
Intel® WM590 Platform Controller Hub
Memory
• Two 260-pin 1.2 V DDR4 SDRAM Small Outline Dual Inline Memory Module (SO-DIMM) sockets
• Support for DDR4 3200 MHz SO-DIMMs
• Support for 8 Gb and 16 Gb memory technology
†
• Support for up to 64 GB of system memory with two SO-DIMMs using 16 Gb memory
technology
†
• Support for non-ECC memory available on all SKUs
• Support for 1.2 V and 1.35 V low voltage JEDEC memory only
• Support for Intel® XMP memory profiles
• Note: 2 Gb memory technology (SDRAM Density) is not compatible
Graphics
• Integrated graphics support for processors with Intel® Graphics Technology:
• One High Definition Multimedia Interface* (HDMI*) v2.0b back panel connector
• Two DisplayPort signals via USB Type C back panel connectors
Audio
• Intel® High Definition (Intel
®
HD) Audio via the HDMI and Type C interfaces through the
processor
• USB Audio via a stereo 3.5mm combination microphone/headphone on the front panel
Storage
• NUC 11 Extreme Compute Element:
• One PCIe Gen4 x4 NVMe M.2 2280.
• Two SATA 6.0 Gb/s or PCIe Gen3 x4 AHCI, NVMe ports are reserved for M.2 storage modules
supporting M.2 2242, M.2 2280 Note: Supports key type M (PCI Express* x1/x2/x4 and SATA),
• On the baseboard:
• One PCIe Gen4 x4 NVMe only port for M.2 modules supporting M.2 2280, or M.2 22110.
Peripheral
Interfaces
• USB 3.2 (Gen 2/10 Gbps) Type C ports:
• Two ports are implemented via the back panel Type C connectors
• USB 3.2 (Gen 2/10 Gbps) Type A ports:
• Six ports are implemented via the back panel connectors (blue)
• Two ports via the desktop front panel (black)
• USB 2.0 ports:
• Two ports via two single-port internal 1x4 1.25 mm pitch headers (contained in the 20pin
Common IO Header)
• SD Card Reader:
• One UHS-II capable SDXC Card Reader on Front Panel
Chassis
Expansion
Capabilities
• One PCIe 4.0 x16 slot* with support for a dual slot GPU up to ~12” (300mm) maximum length
• One PCIe 4.0 x4 slot* with support for full height cards up to ~8’’ (202mm) maximum length
• One M.2 4.0 x4 (NVMe only) on underside of chassis
• Note: PCIe 4.0 x16 slot will run in x8 mode if either M.2 x4 slot or PCIe x4 slot are used from
internal chassis baseboard
NUC Element
Expansion
Capabilities
• Three M.2 connectors supporting AHCI and NVME protocols (only Slot 1 and Slot 2 support
AHCI)
• Two Thunderbolt™ 4 via back panel Type C connectors
BIOS
• Intel
®
BIOS resident in the Serial Peripheral Interface (SPI) Flash device
• Support for Advanced Configuration and Power Interface (ACPI), Plug and Play, and System
Management BIOS (SMBIOS)
Wireless LAN
• Intel® Wi-Fi 6E AX210, 802.11ax, Dual Band, 2x2 Wi-Fi + Bluetooth 5.2
• Maximum Transfer speed up to 2.4 Gbps