User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 Video Configuration
- 3.3.3 PCH-FW Configuration
- 3.3.4 Trusted Computing
- 3.3.5 CPU Configuration
- 3.3.6 Graphic Configuration
- 3.3.7 PCI Express Configuration
- 3.3.8 SATA And RST Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 Power Management
- 3.3.13 Super IO Configuration
- 3.3.14 Serial Console Redirection
- 3.3.15 Miscellaneous
- 3.3.16 Realtek PCIe GBE Family Controller (MAC:00:E0:4C:68:00:0B)
- 3.3.17 APM Configuration
- 3.3.18 EZ-Flash
- 3.3.19 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
N5105I-IM-A R2.0
2-16
CAUTION: Do not forget to connect the fan cables to the fan headers.
Insufcient air flow inside the system may damage the motherboard
components. These are not jumpers! Do not place jumper caps on the fan
headers!
7. Chassis Fan header (4-pin CHA_FAN)
Connect the fan cable to the fan header on the motherboard, ensuring that
the black wire of the cable matches the ground pin of the header.
CHA_FAN
O_CHAFAN_PWM_Q
O_CHAFANIN_R
12V
GND
PIN 1
Connector type
WAFER HD 4p, 2.54mm pitch, S/T
8. SATA Power connectors (4-pin SATA_PWR1/2)
These connectors are for the SATA power cables. The power cable plug
is designed to t this connector in only one orientation. Find the proper
orientation and push down rmly until the connector completely t.
B
A
SATA_PWR2
SATA_PWR1
+12V
GND
GND
+5V
PIN1
A
B
IMPORTANT: The SATA power connector supports 1A current to the
maximum.