User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 Video Configuration
- 3.3.3 PCH-FW Configuration
- 3.3.4 Trusted Computing
- 3.3.5 CPU Configuration
- 3.3.6 Graphic Configuration
- 3.3.7 PCI Express Configuration
- 3.3.8 SATA And RST Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 Power Management
- 3.3.13 Super IO Configuration
- 3.3.14 Serial Console Redirection
- 3.3.15 Miscellaneous
- 3.3.16 Realtek PCIe GBE Family Controller (MAC:00:E0:4C:68:00:0B)
- 3.3.17 APM Configuration
- 3.3.18 EZ-Flash
- 3.3.19 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-7
Chapter 2: Motherboard information
2. Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of the system
setup information such as date, time, and system passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the two pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <Del> key during the boot process and enter BIOS setup
to re-enter data.
NOTE: If the steps above do not help, remove the onboard battery and move
the jumper again to clear the CMOS RTC RAM data. After clearing the CMOS,
reinstall the battery.
CLRTC
GND
+BAT
PIN 1
Connector type
HEADER 1x2p, 2.54mm pitch, S/T