User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 Video Configuration
- 3.3.3 PCH-FW Configuration
- 3.3.4 Trusted Computing
- 3.3.5 CPU Configuration
- 3.3.6 Graphic Configuration
- 3.3.7 PCI Express Configuration
- 3.3.8 SATA And RST Configuration
- 3.3.9 Network Stack Configuration
- 3.3.10 USB Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 Power Management
- 3.3.13 Super IO Configuration
- 3.3.14 Serial Console Redirection
- 3.3.15 Miscellaneous
- 3.3.16 Realtek PCIe GBE Family Controller (MAC:00:E0:4C:68:00:0B)
- 3.3.17 APM Configuration
- 3.3.18 EZ-Flash
- 3.3.19 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-5
Chapter 2: Motherboard information
2.4 System memory
This motherboard comes with two Double Data Rate 4 (DDR4) Small Outline Dual Inline
Memory Module (SO-DIMM) sockets. The gure below illustrates the location of the DDR4
SO-DIMM sockets:
Channel
Sockets
Channel A DIMM_A1
Channel B DIMM_B1
DIMM_A1
DIMM_B1
IMPORTANT!
• You may install varying memory sizes in Channel A and Channel B. The
system maps the total size of the lower-sized channel for the dual-channel
conguration. Any excess memory from the higher-sized channel is then
mapped for single-channel operation.
• Always install the DIMMS with the same CAS Latency. For an optimum
compatibility, we recommend that you install memory modules of the same
version or data code (D/C) from the same vendor. Check with the vendor to
get the correct memory modules.
• According to Intel
®
CPU spec, DIMM voltage below 1.35V is recommended
to protect the CPU.
NOTE: Visit the ASUS website at www.asus.com for the latest QVL.
To install a SO-DIMM
3
2
To remove a SO-DIMM
3
2