User's Manual

第二章：BIOS 信息2-16
Pre-Defined LVDS Panel Type [Auto]
可設置用於內部顯示設備的 LVDS 面板。設置值有： [Auto] [640x480]
[800x600] [1024x768] [1280x1024] [1400x1050(RB) LVDS1]
[1400x1050 LVDS2] [1600x1200 LVDS] [1366x768 LVDS]
[1680x1050] [1920x1200] [1440x900 LVDS] [1600x900 LVDS]
[1024x768 LVDS2] [1280x800] [1920x1080 LVDS]
EDID Data Source [Flat Panel Display]
設置值有： [Pre-defined] [Flat Panel Display]
Screen Brightness [Neutral]
可設置顯示亮度。設置值有： [Dimmest] [Dimmer] [Dim] [Neutral] [Bright]
[Brighter] [Brightest]
Channel Select [Single Channel]
設置值有： [Dual Channel] [Single Channel]
Mode Select [8bit Mode(JEIDA)]
設置值有： [8bit Mode(JEIDA)] [8bit Mode(VESA)] [6bit Mode(VESA and
JEIDA)]
Panel Power Sequence Control [Enabled]
設置值有： [Enabled] [Disabled]
Panel_Vcc ON to Video_Data ON (T8) [20 ms]
設置值有： [10 ms] [20 ms] [30 ms] [40 ms]
Video_Data ON to BKLT_PWM ON (T9) [250 ms]
設置值有： [100 ms] [200 ms] [250 ms] [300 ms]
BKLT_PWM ON to BKLT_Enable ON (T10) [15 ms]
設置值有： [10 ms] [15 ms] [20 ms] [25 ms]
BKLT_Enable OFF to BKLT_PWM OFF (T11) [10 ms]
設置值有： [5 ms] [10 ms] [15 ms] [20 ms]
BKLT_PWM OFF to Video_Data OFF (T12) [250 ms]
設置值有： [100 ms] [200 ms] [250 ms] [300 ms]
Video_Data OFF to Panel_Vcc OFF (T13) [20 ms]
設置值有： [10 ms] [20 ms] [30 ms] [40 ms]
Min Panel_Vcc OFF Time (T15) [600 ms]
設置值有： [600 ms] [700 ms] [800 ms] [1000 ms]
LVDS Spread Spectrum Control [+/- 0.5% Center Spread]
設置值有： [Disabled] [+/- 0.5% Center Spread] [+/- 1% Center Spread]
2.5.4 SATA 設置（SATA Configuration）
當您進入 BIOS 設置程序時，程序會自動檢測系統已存在的 SATA 設備。若對應接
口中沒有安裝 SATA 設備，則【SATA Port】項目顯示為 [Empty]。
SATA Controller [Enabled]
可開啟或關閉 SATA 設備。設置值有： [Disabled] [Enabled]