User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 Onboard Devices Configuration
- 4.4.12 Miscellaneous
- 4.4.13 APM Configuration
- 4.4.14 EZ-Flash
- 4.4.15 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
Single Board Computer 71
4.4.10 USB Configuration
NOTE: The USB Devices item shows the auto-detected values. If no
USB device is detected, the item shows None.
XHCI Hand-off
NOTE: This item is set to [Disabled] by default for the EHCI (enhanced
host controller interface) support by XHCI drivers in operating systems.
[Enabled] Support XHCI by BIOS for operating systems without XHCI
support.
[Disabled] Support XHCI by XHCI drivers for operating systems with XHCI
support.
USB Mass Storage Driver Support
Allows you to enable or disable the USB Mass Storage driver support.
Configuration options: [Disabled] [Enabled]