User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 Onboard Devices Configuration
- 4.4.12 Miscellaneous
- 4.4.13 APM Configuration
- 4.4.14 EZ-Flash
- 4.4.15 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
58 Single Board Computer
LFP Panel Type
Allows you to select LFP panel used by Internal Graphics Device.
Configuration options: [VBIOS Default] [640x480] [800x600] [1024x768]
[1280x1024] [1400x1050 L
VDS1] [1400x1050 LVDS2] [1600x1200] [1366x768]
[1680x1050] [1920x1200] [1440x900] [1600x900] [1024x768] [1280x800]
[1920x1080] [2048x1536]
Inverter Polarity
Allows you to set the inverter board polarity.
Configuration options: [Inverted] [Normal]
NO
TE:
• Normal: PWM = 0% (Dim)
Inverted: PWM = 0% (Bright)
•
Consult inverter board specifications for proper value.
Channel Select
Configuration options: [Dual Channel] [Single Channel]
Mode Select
Configuration options: [JEIDA] [VESA 6bit] [VESA 8bit] [VESA 10bit]