User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 Onboard Devices Configuration
- 4.4.12 Miscellaneous
- 4.4.13 APM Configuration
- 4.4.14 EZ-Flash
- 4.4.15 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
Single Board Computer 57
4.4.1 LVDS Configuration
Switch to LVDS
Allows you to enable or disable Switch to LVDS.
Configuration options: [Disable] [Enable]
NOTE: The following item appears when you set Switch to LVDS to
[Enabled].
All-in-One Chassis
Allows you to select All-in-One (AiO) chassis (if applicable) for simplified AiO
configuration.
Configuration options: [None] [1920*1080 LVDS1] [1920*1080 LVDS2]
[1920*1080 L
VDS3] [1600*900 LVDS4]
NOTE:
• Be cautious when selecting AiO chassis. Incorrect selection of AiO
chassis can cause incorrect operation or potential damage to AiO
chassis hardware.
• The following items appear only when you set All-in-One Chassis
to [None].
EDID Data Source
Configuration options: [Pre-defined] [Flat Panel Display]
NOTE: The following item appears when you set EDID Data Source to
[Pre-defined].