User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 Onboard Devices Configuration
- 4.4.12 Miscellaneous
- 4.4.13 APM Configuration
- 4.4.14 EZ-Flash
- 4.4.15 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
48 Single Board Computer
3.8 Installing a heat spreader
1. Place the heat spreader with its copper pad and thermal interface
material facing up on a flat surface.
2. Remove the plastic protective film from the copper pad and thermal
interface material on the heat spreader, if there is one.
3. Orient the motherboard so that the CPU and chipset on its backside are
in direct contact with the copper pad on the heat spreader, and the five
(5) screw holes on the motherboard are aligned to the five (5) standoffs
on the heat spreader.
Copper pad & thermal
interface material
Screw hole
Standoff