User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 Onboard Devices Configuration
- 4.4.12 Miscellaneous
- 4.4.13 APM Configuration
- 4.4.14 EZ-Flash
- 4.4.15 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
Single Board Computer 45
3.6 Installing an M.2 SSD
1. (Optional) Replace the standoff if it has been removed, or move and
install it based on the length of your M.2 SDD.
2. Align and insert the M.2 SSD into its slot inside the Single Board
Computer.
3. Gently push down the M.2 SSD on top of the standoff, and then fasten
it using a screw.