User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Super IO Configuration
- 4.4.7 Serial Console Redirection
- 4.4.8 SATA Configuration
- 4.4.9 Network Stack Configuration
- 4.4.10 USB Configuration
- 4.4.11 Onboard Devices Configuration
- 4.4.12 Miscellaneous
- 4.4.13 APM Configuration
- 4.4.14 EZ-Flash
- 4.4.15 Watchdog Timer
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 Updating your BIOS
- Appendix
Single Board Computer 63
CPU - Power Management Control
Intel(R) SpeedStep(tm)
Allows more than two frequency to be supported.
Configuration options: [Disabled] [Enabled]
I
ntel(R) Speed Shift Technology
Allows you to enable or disable Intel(R) Speed Shift Technology
support. When enabled, CPPC v2 interface allows hardware controlled
P-states.
Configuration options: [Disabled] [Enabled]
T
urbo Mode
Allows you to enable or disable processor Turbo Mode (requires Intel
Speed Step or Intel Speed Shift to be available when enabled).
Configuration options: [Disabled] [Enabled]
C sta
tes
Allows you to enable or disable CPU Power Management. Allows CPU
to go to C states when it’s not 100% utilized.
Configuration options: [Disabled] [Enabled]
NO
TE: The following item appears only when C states is set to
[Enabled].
Enhanced C-States
Allows you to enable or disable C1E. When enabled, CPU will switch to
minimum speed when all cores enter C-State.
Configuration options: [Disabled] [Enabled]
P
ower Limit 1
Allows you to configure Power Limit 1 value in milliwatts (e.g., enter
12500 for 12.5 W).Power Limit 1
Power Limit 2
Allows you to configure Power Limit 2 value in milliwatts (e.g., enter
12500 for 12.5 W).