User Guide

Avolites Pearl 2000 Operators Manual - page 84
P2000MAN.DOC 19/10/99 17:59
• Press Softbutton B [RECALL FOCUS]. Puts you back in the LIVE PROGRAM
menu.
8.7 Editing a Preset Focus
⇒ When you press this button, the LEDs on the Attribute Bank indicate the
current Focus Mask, and hence the Attributes being recalled into the
Programmer. If necessary, select a different Attribute Bank to recall the
Attributes you intend.
ALL THE FIXTURES IN THAT PRESET FOCUS WILL GO TO THEIR
PRESET FOCUS VALUES. THESE VALUES ARE PUT IN THE
PROGRAMMER PRIOR TO RE-RECORDING. See Section 1.6 The
Programmer.
Or :
8.8 Deleting a Preset Focus
This method can be used to DELETE Preset Focuses 1 – 30 from the grey
buttons.
• Turn the Key to Program. Puts you in LIVE PROGRAM MODE.
• Press the blue DELETE button on the Program Select bank. Its LED lights
up.
• Press the Preset Focus button TWICE to delete it. Delete LED will go out.
⇒ Preset Focuses 1 – 60 can be DELETED from the Graphics Tablet. See
section 15.7.3 DELETING a Preset Focus using the Tablet.
Preset Focuses 61 – 120 cannot be DELETED at present, although you
could turn all Attributes in all Fixtures OFF to achieve the same thing.
(See section 8.13 Switching OFF Attributes in Preset Focuses.) A
DELETE function accessed through the grey FOCUS button is
anticipated in a future Software release.
• Turn the Key to Program. Puts you in LIVE PROGRAM MODE.
• Select the appropriate Attribute Bank.
• Press the blue EDIT FOCUS button on the Program Select Bank.
• Press the Preset Focus ADD button or enter the Preset Focus number
and press ENTER.
• Make the desired changes to the Preset Focus.
• Press the blue STORE FOCUS button on the Program Select bank Again
the Focus Mask is displayed on the LEDs.
Either :
• To store Preset Focuses 1 – 30, press the same Preset Focus button to
store the edits
• Enter the number of the Preset Focus you wish to store, from 1 to 120.
• Press ENTER to confirm.