User Guide

Avolites Pearl 2000 Operators Manual - page 81
P2000MAN.DOC 19/10/99 17:59
Bank Attribute Default Focus Mask
1 DIMMER
ALL ATTRIBUTES
2
SHUTTER
IRIS
SHUTTER
IRIS
3
PAN
TILT
PAN
TILT
4
COLOUR WHEEL 1
COLOUR WHEEL 2
COLOUR WHEELS 1 & 2
YELLOW / EFFECT
MAGENTA / CYAN
5
FOCUS
ZOOM
FOCUS
ZOOM
6
GOBO WHEEL 1
GOBO WHEEL 2
GOBO WHEEL 1
GOBO WHEEL 2
7
GOBO SPIN 1
GOBO SPIN 2
GOBO SPIN 1
GOBO SPIN 2
8
SPEED
PAN & TILT SPEED
SPEED
PAN & TILT SPEED
9
YELLOW
EFFECT
COLOUR WHEELS 1 & 2
YELLOW / EFFECT
MAGENTA / CYAN
10
MAGENTA
CYAN
COLOUR WHEELS 1 & 2
YELLOW / EFFECT
MAGENTA / CYAN
11 (SHIFT KEY) -
12 (REDUCE FIXTURE INTENSITY) -
8.3.3 To check the settings on the Focus Mask
To see the settings on the Focus Mask for each Attribute Bank, you can do
the following.
• Press CLEAR to ensure that nothing is Selected.
• Press the Blue STORE FOCUS button. The Focus Mask for the current
Attribute Bank is shown by the LEDs illuminated on the Attribute Bank
buttons. In most cases they will only have one Attribute, and that will be
identical to the Bank you are currently in.
• Select any other Attribute Banks, and see the Focus Masks for them.
Have a look at the LAMPS bank, and the Colour Banks.
• Press the STORE FOCUS button again to exit. The lit LED now indicates
the Attribute Bank you are in, not the Focus Mask of that Bank.
8.3.4 Using the Focus Mask
You will notice that the LAMPS Focus Mask has all Attributes enabled. Be
very careful – this means that if you store OR EDIT Preset Focuses from
the LAMPS Bank, it will store current values for all Attributes in the
Programmer. This will overwrite other values for Attributes stored on
this Preset Focus!!