User Guide

Avolites Pearl 2000 Operators Manual - page 68

P2000MAN.DOC 19/10/99 17:59

• If you need to change more steps, any information currently in the

Programmer from editing the previous step can be applied to other steps

by simply using the STOP button to step onto the next step to be edited,

and pressing the REC. STEP then the ENTER buttons.

Otherwise press CLEAR and make different edits to the next step.

7.13.2 Changing the current Step Time using LIVE TIME

This enables you to enter edit the Times of the live Step of a Connected

Chase. The Step number is displayed on the VGA monitor as LIVE, and is

defined as the last step to have been completely executed.

• Turn the Key to Program. Puts you in LIVE PROGRAM MODE menu.

• Connect the Chase to be Edited.

• STOP the Chase.

• Either use the STOP button to step onto the Chase Step to be edited,

or type the step number into the Keypad and press CONNECT followed

by STOP. Places the step to be edited in the Programmer.

• Press the LIVE TIME button. Puts you into the TIME INTO LIVE menu. This looks

like the EDIT TIMES menu.

• Enter Fade and Wait times for the Step being edited as if you were in the

EDIT TIMES menu. (See Section 7.10 The EDIT TIMES menu.)

• Press ENTER for these changes to be effected. Puts you back in the LIVE

PROGRAM MODE menu.

• Press CLEAR to release Channels from the Programmer.

7.13.3 Changing the next Step Time using NEXT TIME

This enables you to enter edit the Times of the next Step of a Connected

Chase. The Step number is displayed on the VGA monitor as NEXT, and is

defined as the next Chase Step that will be completed. It may already have

started to execute.

• Connect the Chase to be Edited.

• STOP the Chase.

• Either use the STOP button to step onto the step before Chase Step to

be edited,

or type the step number into the Keypad and press CONNECT. Lines up

the entered Step number as the next Step to be run.