User Guide

Avolites Pearl 2000 Operators Manual - page 66
P2000MAN.DOC 19/10/99 17:59
7.10.7 Link ON or OFF
Linked Chase steps automatically run on one from the next. If you Unlink
any steps, the Chase will stop at the Unlinked Step, and you have to press
the Playback ADD button or the GO button to restart the Chase.
You must have the Chase Connected to restart it using the GO button.
7.10.8 Entering a Fade or Wait time
You can enter different times for each timer using its Softbutton.
Softbutton A [WAIT IN]
Softbutton B [WAIT OUT]
Softbutton C [FADE IN]
Softbutton D [FADE OUT]
Softbutton E [LTP FADE]
Softbutton F [LTP WAIT]
Softbutton G [LINK = ON / OFF]
Under each Softbutton label on the Screen is the time for that Timer.
The time can range from tenths of a second to 12 hours.
• Set each time by entering the time on the Keypad and pressing the
appropriate Softbutton. Use the decimal point to separate hours,
minutes, seconds and fractions of a second.
For example
To set a time of 45 minutes :
Press 4 5 . . then the relevant Softbutton.
To set a time of 1 minute 10 seconds :
Press 1 . . 1 0 then the Softbutton [ A - F]
To set a time of half a second (0.5 seconds) :
Press . 5 then the Softbutton [A - F]
• Press ENTER to record the Times.
7.11 Using the ADD and SWOP buttons when replaying a Chase
The effects vary considerably depending on how you have the desk
configured, and which Run mode you are using. See Chapter 13 Running
your show for more details.
7.12 Editing Global Chase Times
7.12.1 Editing Global Chase Times using the Wheels
Connecting a Chase and using the Wheel(s) in the normal way applies
Global times to a Chase.
7.12.2 Changing Global Chase times using the EDIT TIMES menu Wheels
• Record the Chase you want as a normal Chase using the method in
Section 7.2 Programming a Chase above.
• Press Softbutton C [EDIT TIMES].