User Guide

Avolites Pearl 2000 Operators Manual - page 55
P2000MAN.DOC 19/10/99 17:59
• Press the SWOP button of the Playback Channel you want to record the
Memory onto. The Memory is now recorded. The LED on the Playback Channel will
light to indicate it has something recorded on it and the LED on the MEMORY button
goes out.
• Press CLEAR to clear the Programmer.
⇒ If the Playback Fader is not at zero, you must lower it to zero before you
raise it again to recall the Memory.
It is very important to get into the habit of pressing CLEAR, to ensure
that you do not end up recording Channels into your next Memory or
Chase that are not intended.
6.3 Using the TIMES menu
You may want your Memory to have Fade Time information programmed into
it.
• Record the scene you want as a normal Memory. See Section 6.2
Programming a Memory above.
• Press Softbutton C [EDIT TIMES].
• Either press the ADD or SWOP button of the Playback Fader of the
Memory you wish to add Timing to, or type in the Playback Fader
number and press ENTER.
There are six Timers on the TIMES menu.
A Memory can only have FADE times. Putting values in WAIT times will
have no effect.
6.3.1 Fade In Time
The Fade In time is the time it will take the HTP Channels to fade in when
the Memory is activated.
6.3.2 Fade Out time
The Fade Out time is the time it will take the HTP Channels to fade out
when the Memory is deactivated.
6.3.3 LTP Fade Time
The LTP Fade is the time it will take of all the Fading LTP Channels to
complete their crossfade.
See Section 4.4 INSTANT and FADING Channels.
6.3.4 Entering a Fade time
You can enter different times for each timer using its Softbutton.