User Guide

Pearl 2000 November 1999 release notes - page 18
p2000.doc 12/11/99 18:34
[Playback ADD button 12] This works like the main GO button
[Playback SWOP button 12] This works like the main STOP button
[Playback ADD buttons 13-15] Press to GO on the timers HTP-IN,
HTP-OUT, and LTP respectively
[Playback SWOP buttons 13-15] Press to stop the timers for the HTP-IN,
HTP-OUT, and LTP respectively
[Playback LED 12] This LED will blink when the theatre playback master
fader is at 0. All other times it shows the fader level.
[Playback LEDs 13 to 15] These LEDs indicate the Timed fader level for the
HTP-IN, HTP-OUT, and LTP timers respectively.
Wheels When the Time fade is stopped the wheels can used to manually
adjust the fade up or down. The wheels simultaneously operate the fade for
all 3 time faders and the 2 wheels work together. For individual time fade
control use the playback faders. At the end of the step the wheels must be
turned anti-clockwise before the next step is loaded.
Fader 12 – this is the Intensity master for the Theatre stack.
Faders 13,14 and 15 - When the time faders are stopped these playback
faders can be used to manually adjust the fade up or down. To take over
control, move the fader to full then back down to the current position of the
time fade.
REMOTE CONTROL
The following keys, on the remote control, are available for controlling
a theatre stack.
BLANK (Bottom left key) - GO (works only when stopped)
AT% 100% - STOP
7 - SNAP BACK (use to undo a GO)
8. Known Problems
8.1 Importing an April 99 Sapphire 2000 show disk
If an attempt is made to import more than 240 dimmers or fixtures then those
fixtures or dimmers, which were patched after the 240
th
Fixture or dimmer,
will not be imported.