User Guide

Pearl 2000 November 1999 release notes - page 17
p2000.doc 12/11/99 18:34
7.4.2.7.4 [F] –5%
Reduce the intensity by 5% for all of the Fixtures in the Editor, clamped at
0%.
7.4.2.7.5 [G] 100%
Set the intensity to 100% for all of the Fixtures in the Editor,
7.4.2.7.6 [NUMERIC]
Set the Intensity to (10% multiplied by the input digit) for all of the Fixtures in
the Editor, for example if 5 is input then the intensity is set to 50%
7.4.2.7.7 [.], Decimal point
Follow this by a number to set the intensity units. For example if the selected
fixtures are set to 53% intensity and [.] followed by 7 is input then the
intensity will be changed to 57%.
7.4.3 [C] SET TIMES
Set the Times for the Current step. If the step exists then its times are
presented otherwise the previous recorded times.
7.4.4 [D] RECORD
See Section 7.4.2.4
7.4.5 [E] SET LEGEND
Set the legend for the Current Step
7.4.6 [F] Cut To Live
Input a Step number then hit this key to make the step live on the stage.
NOTE if the step does not exist, a blank step will be created. The step
number is assigned from the input and the times will be set from the last
input times.
7.4.7 [G] QUIT
Use this option to EXIT the Theatre Stack menus.
7.4.8 [DELETE]
Delete a single step or all steps.
7.5 Playback Options
The Pearl will always be in RUN MODE TAKEOVER when the theatre stack
is enabled.
In playback mode the following functions are available
STOP Press to stop the Theatre stack
GO Press to launch the step, or if the step has been stopped part way
through a fade, then continue the step. If GO is pressed while a step is
fading then the current fade will stop (not complete) and the next step will be
loaded and faded to.