User Guide

Pearl 2000 November 1999 release notes - page 16
p2000.doc 12/11/99 18:34
7.4.2.3 [C] ODD or EVEN
When first used, a list is created made up of the Fixtures in the EDITOR.
Thereafter: -
• When ODD is selected the ODD numbered Fixtures are loaded
into the Editor from the remembered list.
• When EVEN is selected the EVEN numbered Fixtures are loaded
into the Editor from the remembered list.
The list is cleared when a new fixture selection is made.
NOTE The order in which the fixtures were selected is preserved in the
remembered list and is used to decide the ODD and EVEN placements.
7.4.2.4 [D] RECORD
7.4.2.4.1 [A] CHANNEL OR FIXTURE RECORD
Alters the Record Option between Record by Channel and Record by
Fixture, the current setting is shown on the prompt line.
7.4.2.4.2 [B] RECORD STAGE
All Fixtures, which are in the programmer together with all Fixtures that are
ON on the stage, are recorded into the Current step.
7.4.2.4.3 [C] SET TIMES
The times are presented for the current step.
Press [ENTER] to save the times or [EXIT] to cancel the changes. If the
Current step does not exist then the previously entered times will be
presented.
7.4.2.4.4 [D] RECORD PROGRAMMER
All Fixtures, which are in the programmer or in the Editor are recorded into
the Current step. If a step number is entered then this will be assigned to the
Current step before recording.
7.4.2.5 GROUP
Input a Group number in the range 1-200, then hit [ENTER] to load it.
7.4.2.6 THROUGH
Select a range of Fixtures, for example 1 THROUGH 10 to select all Fixtures
in the range from 1 To 10.
7.4.2.7 AT %
Set the intensity for the Fixtures in the Editor. To set the intensity to 46%
press [AT%], [4], point(.), [6]
7.4.2.7.1 [A] LOCATE FIXTURE
Switch ON the Fixtures so that it is in open white on the stage (unless BLIND
mode is selected), without actually placing the Fixture’s attributes into the
programmer.
7.4.2.7.2 [B] BLACKOUT
All Fixtures, which are ON on the stage, are first loaded into the Editor and
then set to zero intensity, the result is that the stage is blacked out.
7.4.2.7.3 [E] +5%
Increase the intensity by 5% for all of the Fixtures in the Editor, clamped at
100%.