User Guide

Avolites Pearl 2000 Operators Manual - page 112
P2000MAN.DOC 19/10/99 17:59
12.6 Setting 6. Not used
12.7 Setting 7. Not Used
12.8 Setting 8. TC CHECK ENABLE / DISABLE
This setting displays the current status of the Timecode Checking operation.
See section 17.10 Timecode Checking.
12.9 Setting 9. AUTOCONNECT
Enabling the Chase Autoconnect means that the most recently replayed
Chase will automatically be Connected to the Wheel(s).
As you change Pages and Facets on the Roller, the most recently
Connected Chase will Autoconnect.
Use this Mode for fast access to Chases as they are replayed.
12.10 Setting 10. Remote Connected / G - Tablet
This mode configures the Serial Port on the back of the desk for different
input devices. Select the appropriate mode for running a Stage Remote or
Graphics Tablet. See Chapter 15 The Graphics Tablet and Chapter 15 The
Stage Remote.
⇒ If a connected device does not appear to be working correctly, toggling
the settings on this User Setting until the correct setting is reselected
may help.
12.11 Setting 11. Not used
12.12 Setting 12. Not used
12.13 Setting 13. SPEED IN SECONDS / BPM
This allows you to decide whether the Chase speeds are displayed in
Seconds or Beats Per Minute.
12.14 Setting 14. FRAME + (X) mcS
This User Setting allows the DMX transmission speed to be slowed down
because certain Dimmers and Fixtures cannot respond to full speed DMX
This slightly diminishes the performance of the desk, but will avoid low
specification devices missing DMX instructions. The larger the value of X,
the slower the desk response will be.
The Left Cursor key slows it down.
The Right Cursor Key speeds it up again.
12.15 Setting 15 - MIDI Disabled / Master / Slave
Toggling the settings here either disallow incoming MIDI note on / note off
information, or allow it and set the desk to Master or Slave. In Master, the
desk broadcasts note on / note off information. In Slave, it responds to it.