User Guide

Avolites Pearl 2000 Operators Manual - page 111
P2000MAN.DOC 19/10/99 17:59
12. The USER SETTINGS MENU
The USER SETTINGS Menu allows you configure certain features of the
desk.
• Turn the Key to Program. Puts you in Live Program Mode menu.
• Press Softbutton B [USER SETTINGS]. Puts you in the User Settings Menu.
Use the Up and Down Cursor Keys to move up and down the Menu.
Use the Left and Right Cursor Keys to toggle menu options.
12.1 Setting 1. CHASE PARAMETERS
Does nothing. This function is transferred to Softbutton A in the Live
Program Mode menu.
12.2 Setting 2. FADER OFF AT XX
This setting sets the level at which the Playback Fader stops a sequence
running.
This value must be lower than the MEMORY FADER ON value. (See below.)
12.3 Setting 3. FADER ON AT XX
This setting sets the level of the Trigger Point at which LTP functions are
activated on the Playback Channels. it also sets the level at which Chases
start to run.
This value must be lower than the MEMORY FADER OFF value. (See
above.)
12.4 Setting 4. Run Modes
The available Run Modes are :
12.4.1 NORMAL RUN MODE
12.4.2 TAKEOVER RUN MODE
12.4.3 TWO PRESET MODE
All these Modes are fully discussed in Chapter 13 Running your show.
12.5 Setting 5. Record Modes
The available Record Modes are :
12.5.1 Record by INSTRUMENT
12.5.2 Record by CHANNEL
All these Modes are fully discussed in Chapter 6.1 Recording Modes.