User Guide

Avolites Pearl 2000 Operators Manual - page 109
P2000MAN.DOC 19/10/99 17:59
⇒ Important notes regarding training:-
The PAN value must be different for each of the corners, as must be the
TILT value. The difference need only be 1 count.
⇒ If you are using moving head Fixtures you should follow the following
guidelines on positioning and setting up:
• Align fixtures as shown in the diagram above.
• When hanging fixtures ensure the pan limit faces away from the training
square.
• When training make sure the tilt level is below 50%.
11.3 Using Tracking without a Graphics Tablet
Once you have trained the desk, you can Track the Fixtures. This is best
done using a Graphics Tablet (See Section 14.10 Using tracking on the
Tablet.), but it is possible from the desk.
• Turn the Key to Program. Puts you in Live Program Mode.
• Press Softbutton H [ML MENU].
• Toggle Softbutton F [TRACKING ON / OFF] so that Tracking ON is
selected.
• Select the Fixtures to Track. Wheel A now controls their movement
upstage / downstage relative to area you have defined, and Wheel B
controls their movement stage left / stage right.
Example of how to place moving head fixtures
with relation to the training square.
Note that the limit stop on the pan movement is
set so it is away from the square.
Direction of pan
movement showing
where the limit stop
must be placed
Fixture
Cable
Pan limit stop position
Bar
training square
down stage
up stage
Defining the stage with moving head fixtures