User Guide

2-6

Chapter 2: Boot Agent Conguration

2.3 Intel(R) Ethernet Flash Firmware Utility

The Intel(R) Ethernet Flash Firmware Utility allows you to switch between PXE option ROM

and iSCSI option ROM. Note that only one option ROM can be used at a time.

To install the PXE option ROM:

1. Locate the

BootIMG.FLB

and

Bootutil.exe

les in the PXE folder on your SDVD.

2. Copy the

BootIMG.FLB

and

Bootutil.exe

les to a bootable USB storage device.

3. Enter DOS environment.

The utility must run under pure DOS environment. It cannot run in a DOS box on Windows

system. You should boot from a DOS oppy without any device drivers

4. Within the DOS environment, enter the directory with the

BootIMG.FLB

and

Bootutil.

exe

les.

5. Install the PXE option ROM:

bootutil.exe -nic=1 -up=pxe+e -quiet

Port 1 and Port 2 share the same ash.

6. Restart the system.

D:\>bootutil.exe -nic=1 -up=pxe+e -quiet

Intel(R) Ethernet Flash Firmware Utility

BootUtil version 1.6.39.1

Programming ash on port 1 with ash rmware image

Flash update successful

Port Network Address Location Series WOL Flash Firmware Version

==== =============== ======== ======= === ============================= =======

1 00E018122208 1:00.0 10GbE YES UEFI,PXE Enabled 2.3.58

2 00E018122209 1:00.1 10GbE YES UEFI,PXE Enabled 2.3.58

D:\>