User Guide
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Extreme Tweaker menu
- 3.6 Advanced menu
- 3.6.1 CPU Configuration
- 3.6.2 Platform Misc Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 ROG Effects
- 3.6.5 PCH Configuration
- 3.6.6 PCH Storage Configuration
- 3.6.7 USB Configuration
- 3.6.8 Network Stack Configuration
- 3.6.9 Onboard Devices Configuration
- 3.6.10 APM Configuration
- 3.6.11 HDD/SDD SMART Information
- 3.6.12 Intel(R) ThunderBolt
- 3.6.1 CPU Configuration
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: Software Support
- 4.1 Installing an operating system
- 4.2 Support DVD information
- 4.3 Software information
- 4.4 AI Suite 3
- 4.5 Dual Intelligent Processors 5
- 4.6 ROG Audio features
- 4.7 Sonic Radar II
- 4.8 GameFirst III
- 4.9 KeyBot II
- 4.10 ASUS Media Streamer
- 4.11 RAMDisk
- 4.12 MemTweakIt
- 4.13 ROG CPU-Z
- 4.14 RAMCache
- 4.15 Lighting Control
- Chapter 5: RAID Support
- Appendix
ASUS MAXIMUS VIII EXTREME
1-39
Chapter 1
3. USB 3.0 connectors (20-1 pin USB3_12; USB3_34)
This connector allows you to connect a USB 3.0 module for additional USB 3.0 front
or rear panel ports. With an installed USB 3.0 module, you can enjoy all the benets of
USB 3.0 including faster data transfer speeds of up to 5 Gbps, faster charging time for
USB-chargeable devices, optimized power efciency, and backward compatibility with
USB 2.0.
The USB 3.0 module is purchased separately.
• These connectors are based on xHCI specication. We recommend you to install the
related driver to fully use the USB 3.0 ports under Windows
®
7, Windows
®
8.1, and
Windows
®
10.
• The plugged USB 3.0 device may run on xHCI or EHCI mode depending on the
operating system’s setting.
2. ASMedia
®
Serial ATA 6 Gb/s connectors (7-pin SATA6G_E12)
These connectors connect to Serial ATA 6 Gb/s hard disk drives via Serial ATA 6 Gb/s
signal cables.