User Guide
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Extreme Tweaker menu
- 3.6 Advanced menu
- 3.6.1 CPU Configuration
- 3.6.2 Platform Misc Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 ROG Effects
- 3.6.5 PCH Configuration
- 3.6.6 PCH Storage Configuration
- 3.6.7 USB Configuration
- 3.6.8 Network Stack Configuration
- 3.6.9 Onboard Devices Configuration
- 3.6.10 APM Configuration
- 3.6.11 HDD/SDD SMART Information
- 3.6.12 Intel(R) ThunderBolt
- 3.6.1 CPU Configuration
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: Software Support
- 4.1 Installing an operating system
- 4.2 Support DVD information
- 4.3 Software information
- 4.4 AI Suite 3
- 4.5 Dual Intelligent Processors 5
- 4.6 ROG Audio features
- 4.7 Sonic Radar II
- 4.8 GameFirst III
- 4.9 KeyBot II
- 4.10 ASUS Media Streamer
- 4.11 RAMDisk
- 4.12 MemTweakIt
- 4.13 ROG CPU-Z
- 4.14 RAMCache
- 4.15 Lighting Control
- Chapter 5: RAID Support
- Appendix
5-2
Chapter 5: RAID Support
Chapter 5
5.1.2 Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance, install
identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
5.1.3 Setting the RAID item in BIOS
You must enable the RAID function in the BIOS Setup before creating RAID sets using SATA
HDDs. To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Advanced menu > SATA Configuration, and then press <Enter>.
3. Set the SATA Mode item to [RAID Mode].
4. Save your changes, and then exit the BIOS Setup.
Refer to Chapter 3 for details on entering and navigating through the BIOS Setup
Due to chipset limitation, when SATA ports are set to RAID mode, all SATA ports run at
RAID mode together.