User guide

Chapter 2: BIOS setup 2-15
The Module Version and USB Devices Enabled items show the auto-detected values. If no
USB device is detected, the item shows None.
USB Functions [Enabled]
Allows you to enable or disable the USB Functions.
Conguration options: [Enabled] [Disabled]
USB 2.0 Controller [Enabled]
Allows you to enable or disable the USB 2.0 Controller.
Conguration options: [Enabled] [Disabled]
Legacy USB Support [Enabled]
Allows you to enable or disable support for USB devices on legacy operating systems
(OS). Setting to Auto allows the system to detect the presence of USB devices at startup.
If detected, the USB controller legacy mode is enabled. If no USB device is detected, the
legacy USB support is disabled. Conguration options: [Disabled] [Enabled] [Auto]
USB 2.0 Controller Mode [HiSpeed]
Allows you to congure the USB 2.0 controller in HiSpeed (480 Mbps) or Full Speed (12
Mbps). Conguration options: [FullSpeed] [HiSpeed]
2.4.6 USB Conguration
The items in this menu allows you to change the USB-related features. Select an item then
press <Enter> to display the conguration options.
The following item may only appear when a USB storage device is plugged.
USB Mass Stroage Device Conguration
USB Mass Stroage Reset Delay [20 Sec]
Allows you to set the USB mass stroage reset delay. Conguration options: [10 Sec] [20 Sec]
[30 Sec] [ 40 Sec]
Emulation Type [Auto]
Allows you to set the emulation type. Conguration options: [Auto] [Floppy] [Forced FDD]
[Hard Disk] [CDROM]