User Manual

4-20 Chapter 4: BIOS setup
Memory Controller
Memory Controller
Memory Conguration
ECC Conguration
Power Down Control [Auto]
Alternate VID [0.850 V]
Memory CLK :667 MHz
CAS Latency(TCL) :5.0
RAS/CAS Delay(Trcd) :5 CLK
Min Active RAS(Tras) :15 CLK
Row Precharge Time(Trp) :5 CLK
RAS/RAS Delay(Trrd) :3 CLK
Row Cycle (Trc) :21 CLK
Asynchronous Latency :6 ns
Memory Conguration
The memory conguration menu allows you to change the memory settings.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Memory Conguration
Memclock Mode [Auto]
MCT Timing Mode [Auto]
Bank Interleaving [Auto]
Enable Clock to All DIMMS [Disabled]
DQS Signal Training Control [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
CS Sparing Enable [Disabled]
Memory Hole Remapping [Enabled]
Select the DRAM
Frequency program
method. If Auto,
the DRAM speed will
be based on SPDs.
If Limit, the DRAM
speed will not exceed
the specic value.
If Manual, the DRAM
will be programmed
regardless.
Memclock Value [200 MHz]
Sets the memory clock mode limit.
Conguration options: [400 MHz] [533 MHz] [ 667 MHz] [ 800 MHz]
MCT Timing Mode [Auto]
Sets the MCT Timing Mode. Conguration options: [Auto] [Manual]
Bank Interleaving [Auto]
Allows you to enable the bank memory interleaving.
Conguration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Conguration options: [Disabled] [Enabled]
Memclock Mode [Auto]
Sets the memory clock mode.
Conguration options: [Auto] [Limit] [Manual]
The following item appears when the Memclock Mode is set to Limit or Manual.