User Manual

2-20 Chapter 2: Hardware information

6. BIOS Recovery (3-pin RECOVERY1)

This jumper allows you to recover your original BIOS from a oppy disk in

case the BIOS codes and data are corrupted.

To recover the BIOS:

1. Turn OFF your computer and unplug the power cord.

2. Move the jumper cap from pins 2-3 (default) to pins 1-2.

3. Insert a oppy disk with the original or updated BIOS le.

4. Plug the power cord and turn ON the computer.

5. The system searches for the BIOS le in the oppy then reashes

the BIOS.

6. When nished, shut down your computer.

7. Replace the jumper cap from pins 1-2 to pins 2-3.

8. Reboot your computer.

9. Hold down the <Del> key during the boot process and enter BIOS

setup to re-enter data.

M2N-LR/SATA

M2N-LR/SATA BIOS Recovery Setting

RECOVERY1

Enable

(Default)

Disable

2 1

7. SATA controller setting (3-pin SATA_EN1)

(

M2N-LR/SATA model only

)

This jumper allows you to enable or disable the Adaptec

AIC-8130 SATA

RAID controller.

M2N-LR/SATA

M2N-LR/SATA SATA Setting

SATA_EN1

Enable

(Default)

Disable

2 3