Specifications
Table Of Contents
- Contents
- Chapter 1: Product introduction
- Chapter 2: Hardware information
- Chapter 3: Powering up
- Chapter 4: BIOS setup
- Chapter 5: RAID configuration
- Chapter 6: Driver installation
- Appendix: Reference information
- 2.1 Before you proceed
- 2.2 Motherboard overview
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 Expansion slots
- 2.6 Jumpers
- 2.7 Connectors
- A.1 P8B-M block diagram
- A.2 P8B-MX block diagram
2-26 Chapter 2: Hardware information
7. Chassis intrusion connector (2-pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
8. ME rmware force recovery setting (3-pin ME_RECOVERY1)
This jumper allows you to quickly recover the Intel Management Engine (ME)
rmware when it becomes corrupted.