User Guide

ASUS LSI SCSI User’s Manual 7

2. Starting

Setting Interrupts

Normally, you do not change the default interrupt routing for the LSI inte-

grated SCSI, since performance is usually increased by having two separate

interrupts.

Configuring the LSI Integrated SCSI

In most cases you should not need to change the default configuration of your

integrated SCSI. You may decide to alter these default values if there is a con-

flict between device settings, or if you need to optimize system performance.

The following tables list the configuration settings you can change. The global

settings effect your integrated SCSI and all SCSI devices which are connected

to it. The device settings effect only individual SCSI devices.

Global Default Settings

Settings for the Integrated SCSI & All Devices Default Settings

SCAM Support Off

Parity Checking Enabled

Integrated SCSI SCSI ID 7

Scan Order Low to High (0-Max)

Device Default Settings

Settings for Individual SCSI Devices Default Settings

Synchronous Transfer Rate (MB/Sec) 40 or 80

Data Width 16

Disconnect On

Read/Write I/O Time-Out (secs) 10

Scan for Devices at Boot Time Yes

Scan for SCSI LUNs Yes

Queue Tags Enabled