User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Powering Up
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 PSP Firmware Versions
- 4.5.3 APM Configuration
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 CSM Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 SATA Configuration
- 4.5.12 Tls Auth Configuration
- 4.5.13 Network Stack Configuration
- 4.5.14 AMD Mem Configuration Status
- 4.5.15 iSCSI Configuration
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Save & Exit menu
- 4.11 AMD CBS menu
- 4.12 Event Logs menu
- 4.13 Server Mgmt menu
- Chapter 5: Driver Installation
- Appendix
2-23
KRPA-U16
2.8.2 Internal connectors
2. Power Supply SMBus connector (5-pin PSUSMB1)
This connector allows you to connect SMBus (System Management Bus) to the PSU
(power supply unit) to read PSU information. Devices communicate with an SMBus
host and/or other SMBus devices using the SMBus interface.
This connector functions only when you enable ASUS ASMB9.
1. Serial ATA connectors (7-pin SATA1-4)
These connectors, controlled by AMD integrated SATA controller, are for the Serial
ATA signal cables for Serial ATA drives (SATA 1 connector is used for the optical drive
by default).
The actual data transfer rate depends on the speed of Serial ATA hard disks installed.