User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Chapter 5: WebPAM
73
10. Make the following settings as required:
• Choose 64 KB or 128 KB from the Stripe Block Size dropdown menu.
See page 106.
• Choose No Cache, Read Cache or Read Ahead from the Read Cache
dropdown menu. See page 108.
• Choose Write Through or Write Back from the Write Cache dropdown
menu. See page 108.
• Choose Gigabyte Boundary or None from the Gigabyte Boundary
dropdown menu. See page 107.
The Gigabyte Boundary option is available only when you have checked
the Use Maximum Capacity box in step 6.
• Choose Fast Initialization, Full Initialization, or None from the
Initialization dropdown menu. See page 106.
11. Click the Finish button.
If there are physical drives available, the Select RAID Level screen appears
again, where you can create an additional logical drive.
Click the Logical Drive Icon to see all of the information about your new
logical drive.