User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Chapter 5: WebPAM
71
3. Click the option button beside the RAID level you want for your logical drive.
WebPAM displays the RAID levels you can use with the available physical
drives. See “Choosing a RAID Level” on page 104 for more information.
Click the Next button to continue. The Select Drive Group screen appears.
4. In the Select Drive Group screen, click the option button for one of the
following:
• Free Drives – Select all Free (unassigned) physical drives.
• Logical Drive – If you previously created a logical drive but did not
choose Use Maximum Capacity (see step 6) this option appears.
Choose Logical Drive to use the unassigned portion of physical drives
that belong to the existing logical drive.
5. Click the Next button.
The Select Drives screen appears.