User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Chapter 5: WebPAM
59
Managing the Controller
• Viewing Controller Information (below)
• Making Controller Settings (page 59)
• Viewing Scheduled Actions (page 61)
• Deleting a Scheduled Action (page 61)
• Locking the Controller (page 62)
Viewing Controller Information
The term Controller refers to the device that controls your RAID.
To access the controller, click the Controller icon in Tree View.
The Information tab displays with information about the controller.
• Product Name – The Promise product name for this controller.
• BIOS Version – Version number of the controller’s BIOS.
• Driver Version – Version number of the controller’s software driver.
• Maximum Number of Ports – The number of ports on the controller.
• Maximum Physical Drives – The maximum number of physical (disk)
drives the controller can support.
• Maximum Logical Drives – The maximum number of logical drives (arrays)
the controller can support.
Making Controller Settings
To make controller settings:
1. Click the Controller icon in Tree View.
2. Click the Settings tab in Management View.