User Manual
Table Of Contents
- ROMB User Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Installing Drivers
- Chapter 4: RAID Management Utility
- Chapter 5: WebPAM
- Logging into WebPAM
- Logging out of WebPAM
- Managing Users
- Viewing Host Management
- Making Utility Configuration Settings
- Managing the Controller
- Managing Physical Drives
- Managing Logical Drives
- Viewing All Logical Drives
- Creating a Logical Drive
- Creating a JBOD Disk
- Deleting a Logical Drive or JBOD Disk
- Viewing Logical Drive Information
- Making Logical Drive Settings
- Migrating a Logical Drive
- Rebuilding a Logical Drive
- Synchronizing a Logical Drive
- Viewing Logical Drive Initialization
- Activating a Logical Drive
- Responding to a Critical or Offline Logical Drive
- Managing Spare Drives
- Chapter 6: Technology
- Chapter 7: Support
- Appendix A: Partition and Format
- Appendix B: Upgrades
- Index
Chapter 4: RAID Management Utility
45
For RAID 1, 5, and 10 logical drives:
• If the logical drive was not rebuilt, rebuilding begins automatically when
you boot your PC.
• If the logical drive is already rebuilt, the new physical drive shows Free
or unassigned when you boot your PC.
For RAID 0 and SPAN logical drives, rebuilding is not available because
these configurations have no redundancy. You can create a new logical drive
but you must restore your data from a backup source.
For more information, see “Introduction to RAID” on page 97.